Technitool Inc. has begun using a Nissei portable injection unit to give it flexibility to revert to single-shot molding when a two-shot job is finished. Technitool of Berlin, N.J., early this year ...

It's tempting to swap a carburetor for more modern electronic fuel injection. But while such a move can improve your car, it ...

The clearances inside diesel injection system parts are closer than those found in any other technology. The plungers and needle valves in injectors need to fit tightly to ensure precise metering and ...

We have investigated the fundamental characteristics of unit injectors and pump-line-nozzle systems theoretically by a graphical analysis of characteristic lines. We have confirmed the higher ...

This is the twin TBI setup attached to the top of the new cross-ram manifold. Note that fuel enters the left TBI unit first and then on to the right unit before being returned to the tank. Although ...

The criteria for selecting a Liquid Silicone Rubber injection molding machine are very similar to selecting a machine for standard thermoplastic injection molding, with some key differences. Let’s ...

The carburetor was invented well over a century ago and served the internal combustion engine well. Later, electronic control was married to carburetors with so-so results. Okay, the results were ...

Hey, we love carburetors as much as the next gas monkey, but it's hard to beat the driveability advantages of electronic fuel injection. Even if an EFI system doesn't necessarily deliver a performance ...

The original acid-gas injection project near DCP Midstream’s Artesia, NM, gas plant started up in November 2003 and consisted of drilling an injection well and installing an acid-gas injection ...